Printers and Parts (Surplus)

Welcome to Surplus And Prts

Recreus Extruder Base Mountable white 2pcs Plastic PLA only NEMA


Recreus Extruder Base Mountable white 2pcs Plastic PLA only NEMA 17 Motor and hardware not included

Number  1 of 5 for Gyrobot's Extruder Week.
as seen in picture
Like the original, only base mountable at 50mm hole pitch which is Wades compatible.
Quick-Fit version here.
Gyrobot Recreus Extruder
There is a slot for an M6 captive nut so you can add your own hotend or use the Recreus style one.
Full filament support after the MK7 gear wheel allows a PTFE tube insert to be added down into the hotend for flexible filament printing. If you want to know how to print with this type of filament, please read the following article.
tested on Prusa Mendel

Instructions for reference only and following parts are not included in sale

Print with support due to Nema motor recess in rear of model.
If using an M6 all metal hotend mounted directly into this extruder then a 40mm cooling fan mounted on the front face blowing air over the hot end heatsink is a requirement.
Drill out hole if inserting a PTFE liner.

Extruder :
Insert M6 captive nut for hot-end.
Insert M5 captive nut for tensioner.
Tensioner :

M5 locknut
M5 screw
4mm spring
Require Bearing 624 =  ID 4 mm x OD 13 mm x Thickness 5 mm Not included
M4 screw for Bearing

Special Note : Information's are here for your reference only and accuracy can not be guaranteed.

Copyright © 2015 All rights reserved

Add to Cart:

  • Model: Recreus Extruder Base PLA
  • Shipping Weight: 0.4lbs
  • 2 Units in Stock

This product was added to our catalog on Sunday 22 February, 2015.

Your IP Address is:
Copyright © 2019 Powered by Zen Cart
Its Your Very Own Online Shop